Application shows that the recovery rate can be as high as90% in tin ore, Pb ore, antimony ore, sliver ore, gold ore,etc.especially for the case less than 2.5mm heavy ores, can reach to 92%.

Note: The standard slurry density in feeding is 35%, The water pressure level in separation process is 0.03-0.06Mpa.
This figure is only for your reference, for example: named the water pressure as A=0.02mpa, B=0.03mpa, C=0.04mpa, and then testing these three figures to check the gold concentration grade, delete the lowest grade matched figure, and then text again to choose the most suitable water pressure figure.

(1)Central transmission shaft is driven by motor through belt, and then make the inner concentrate cone rotate in high speed.

(2)Fluidization water is introduced into the concentrate cone through central transmission shaft, and then spraying water to ring groove from inner cone holes, called backwash water.The water pressure level in separation process: 0.03-0.06Mpa.

(3)Ineral materials enter into the inner cone groove by feeding pipe, under the high rotating configuration force, heavy ores will be deposited on the groove but the light ores will go upside along the cone liner, and finally going into tailing discharging pipe from cone upper surroundings.During the separation process, make sure the concentration discharging pipe is closed.

(4)After a cycle process, close down the machine and open the concentration pipe to collect the gold concentration.